Schedule Simple Test Frequently

Hello Some,

There are a few possible solutions using the approach you have in mind. All of them involve using the Execution Delay test step. A 15 minute delay equates to 900,000 milliseconds, which is what the Execution Delay test step uses. With this you could:

1) Create a data driven test, not really use the data, add a 15 minute execution delay. I would put it as the first step because if the test ever fails it won't reach the last test step thus skipping your intended 15 minute delay
2) A test list won't really work nicely because you can't add the same test more than once to a test list.
3) You could surround the main steps of your test in a Loop, including the Execution Delay. If the test ever runs into an error, it will step the loop and the test.  

All the best,
Cody
the Telerik team

Cody,
I have made good progress by creating a new test and inserting "Test as Step" steps with each step containing my simple login tests and 15 minute waits in between.  Now my problem is related to failure notifications.  If a failure is encountered I would like my process to continue to run additional wait / test cycles however I would also like each failed "Test as Step" to generate an email on failure.
Not having much luck with this.  I have set my test steps to "Continue on Failure" and for the scheduled task list to email on test failure.  The problem is the failure email is not sent out as soon as a test step fails but instead goes out after the entire test list has completed.  The scenario I would like to support is for a login test to run against an environment every 15 minutes and if that login test should fail (unable to login) an email should be sent out and that test should continue to execute every 15 minutes with a failure email generated until the test begins to complete successfully. 

Thanks,
Nick

Hello Nick,

What I recommend to overcome the problem of sending email on failure is to convert your verification step to code and add code to send an email when the comparison fails. In the process convert the comparison from an Assert to an ordinary If() construct.

All the best,
Cody
the Telerik team

Cody,
How do I get the status of the test?  The steps that are performing the test are from a recorded script with each of those steps set to continue on failure so that when the test ends it can hit my custom coded step.  So how do I determine if any of the preceding steps failed?  If I am going in the wrong direction feel free to correct.

Thanks,
Nick

Hi Some,

That actually is a problem. Currently it is not possible, in a coded step, to get the overall pass/fail status of the entire test while the test is running. Only the OnAfterTestCompleted can get this status. But in your case I believe that is too late (except possible you could do it in a subtest which your parent test repeatedly is calling but I haven't tried this to verify it works). That function only gets called when the test is exiting.

That's why I was recommending you perform some sort of comparison in your code and send your email based on the results of that comparison.

Best wishes,
Cody
the Telerik team

Only the OnAfterTestCompleted can get this status. But in your case I believe that is too late (except possible you could do it in a subtest which your parent test repeatedly is calling but I haven't tried this to verify it works).

Cody,
the OnAfterTestCompleted event does fire when in a subtest and is the direction I went.  That allows me to stick with a fully scripted test and just hook into this event to send an email if required.

Thanks,
Nick

Hello Some,

Excellent news! We'll be here if you need further assistance. Sounds like you've got it well under control at this point.

Best wishes,
Cody
the Telerik team